ASME B16.33-2012 pdf free

ASME B16.33-2012 pdf free.Manually Operated Metallic Gas Valves for Use in Gas Piping Systems Up to 175 psi (Sizes NPS 1/2 Through NPS 2).
ASME B16.33 covers requirements for manually operated metallic valves sizes NI’S i’ through NI’S 2, for outdoor installation as gas shutoff valves at the end of the gas service line and before the gas regulator and meter where the designated gauge pressure of the gas piping system does not exceed 175 psi (12.1 bar). The Standard applies to valves operated in a temperature environment between —20°F and 150°F (—29°C and 66”C).
1.2 Design
This Standard sets forth the minimum capabilities, characteristics, and properties that a valve at the time of manufacture must possess in order to be considered suitable for use in gas piping systems. Details of design and manufacture (other than those stated in this Standard, including such design and production tests that will produce a valve that will have the required capabilities to meet this Standard) remain the responsibility of the manufacturer.
1.3 Standards and Specifications
Standards and specifications adopted by reference in this Standard and the names and addresses of the sponsoring organizations are shown in Mandatory Appendix I. It is not considered practical to refer to a specific edition of each of the standards and specifications in the individual references. Instead the specific edition references are included in Mandatory Appendix I. A product made in conformance with a prior edition of reference standards and in all other aspects conforming to this Standard will be considered to be in conformance even though the edition reference may be changed in a subsequent revision of this Standard.
1.4 QuaLity Systems
Nonmandatory requirements relating to the manufacturer’s quality system program are described in Nonmandatory Appendix A.
1.5 Convention
For determining conformance with this Standard, the convention for fixing significant digits where limits (maximum and minimum values) are specified, shall be as defined in ASTM E29. This requires that an observed or calculated value be rounded off to the nearest unit in the last right-hand digit used for expressing the limit. Decimal values and tolerances do not imply a particular method of measurement.
1.6 Codes and Regulations
A valve used under the jurisdiction of the Code of Federal Regulation (CFR), such as litle 49, Part 192; the ASME Code for Pressure Piping, such as ASME B31.8; or the National Fuel Gas Code, NFI’A 54, is subject to any limitation of that code or regulation.
2 CONSTRUCTION
2.1 General
Each valve at the time of manufacture shall be capable of meeting the requirements set forth in this Standard. The workmanship employed in the manufacture and assembly of each valve shall provide gas tightness, safety, and reliability of performance, and freedom from injurious imperfections and defects.
2.2 Tamperproof Features
Where valves are specified to be tamperproof, they shall be designed and constructed to minimize the possibility of the removal of the core of the valve with other than specialized tools.
2.3 Configuration
2.3.1 Operating Indication. The valve shall be so marked or constructed that the operator can visually determine
(a) when a 1/4 turn valve is in the open or closed position (if flat head, longitudinal axis of the head shall be perpendicular to the longitudinal axis of the valve when valve is in the closed position)
(b) when the valve requires more than turn to operate valve, turning direction to open or close the valve.ASME B16.33 pdf download.