IEC 61076-3-122-2021 pdf free
IEC 61076-3-122-2021 pdf free.Connectors for electrical and electronic equipment – Product requirements – Part 3-122: Detail specification for 8-way, shielded, free and fixed connectors for I/O and data transmission with frequencies up to 500 MHz and current-carrying capacity in industrial environments.
The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies.
For undated references， the latest edition of the referenced document (including any amendments) applies.
IEC 60050-581, International Electrotechnical Vocabulary (IEV)一Part 581: Electromechanical components for electronic equipment
IEC 60068-1, Environmental testing – Part 1: General and guidance
IEC 60068-2-38, Basic environmental testing procedures – Part 2-38: Tests一Test Z/AD: Composite temperature/humidity cyclic test
IEC 60512-99-002, Connectors for electrical and electronic equipment — Tests and measurements — Part-99-002: Endurance test schedules — Test 99b. Test schedule for unmating under electrical load
IEC 60664-1, Insulation coordination for equipment within low-voltage supply systems — Part 1:Principles, requirements and tests
IEC 61076-1:2006. Connectors for electronic equipment — Product requirements — Part 1:Generic specification
IEC 61076-1 :2006IAMD1 :2019
IEC 61076-3, Connectors for electronic equipment — Product requirements — Part 3:Rectangular connectors — Sectional specification
IEC TR 63040, Guidance on clearances and creepage distances in particular for distances equal to or less than 2 mm — Test results of research on influencing parameters
ISO/IEC 11801-1, Information technology — General cabling for customer premises — Part 1:General requirements
3 Terms and definitions
For the purposes of this document, the terms and definitions given in IEC 60050-581, IEC 61076-1. IEC 61076-3 and IEC 60512-1 apply.
ISO and IEC maintain terminological databases for use in standardization at the following addresses:
• IEC Electropedia: available at http:l/www.electropedia.org/
• ISO Online browsing platform: available at http://www.iso.org/obp
4 Mating information
4.1 General
Dimensions are given in millimetres. Drawings are shown in third-angle projection. The shape of connectors may deviate from those given in Table 1 and Figure 2 through Figure 4 as long as the dimensions specified are not changed.
Two types of connectors are defined, which can be used to distinguish between different networks within the same building or premises.IEC 61076-3-122 pdf free download.
