IEC 61169-66-2021 pdf free

IEC 61169-66-2021 pdf free.Radio-frequency connectors – Part 66: Sectional specification for RF coaxial connectors with 5 mm inner diameter of outer conductor, with quick-lock- or screw-coupling, characteristic impedance 50 Q (series 2,2-5).
This part of IEC 61169, which is a sectional specification (SS), provides information and rules for the preparation of detail specifications (DS) for series 2.2-5 RF coaxial connectors with quick-lock- or screw coupling, characteristic impedance 50 0, for operating frequencies up to 6 GHz. Typical use is in wireless telecommunication systems.
It describes mating face dimensions for general purpose connectors — grade 2, gauging information and tests selected from IEC 61169-1, applicable to all detail specifications relating to series 2,2-5 RF connectors.
This specification indicates recommended performance characteristics to be considered when writing a detail specification and it covers test schedules and inspection requirements for assessment levels M and H.
NOTE Metric dimension are original dimensions All undimensioned pictorial configurations are for reference purpose only.
2 Normative references
The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
IEC 61169-1:2013, Radio frequency connectors — Part 1: Generic specification — General requirements and measuring methods
IEC 62037-1:2012, Passive RF and microwave devices, intermodulation level measurement — Part 1: General requirements and measuring methods
3 Terms and definitions
No terms and definitions are listed in this document.
ISO and IEC maintain terminological databases for use in standardization at the following addresses:
• IEC Electropedia: available at http://www.electropedia.org/
• ISO Online browsing platform: available at http://www.iso.org/obp
4 Mating face and gauge information
4.1 Dimensions – General purpose connectors – Grade 2
4.1.1 Connector with pin centre contact
The mating face of connector with pin centre contact is shown in Figure 1 and its dimensions are shown in Table 1.
4.1.2 Connector with socket centre contact
The mating face of connector with socket centre contact is shown in Figure 2 and its dimensions are shown in Table 2.IEC 61169-66 pdf free download.